Why an optical fiber is better than copper?

0
0

Experts say, optical fiber is better than copper wire for Fiber to the home applications. How and why an optical fiber has advantage over copper wires in Fiber to the home deployments?

  • You must to post comments
0
0

Optical fiber is chosen for systems requiring higher bandwidth or spanning longer distances than copper cabling can accommodate.

The main benefits of optical fiber are its low loss which is called attenuation. This allows transmission of signals for long distances between amplifiers/repeaters. Optical fiber signals are free of ground currents and other parasite signal and power issues common to long parallel electric conductor runs. Optical fiber uses light rather than electricity for transmission and the fiber is dielectric. Optical fiber has inherently high data-carrying capacity. Thousands of electrical links would be required to replace a single high bandwidth fiber cable. Another benefit of fibers is that even when run alongside each other for long distances, fiber cables experience effectively no crosstalk, in contrast to some types of electrical transmission lines. Fiber can be installed in areas with high electromagnetic interference (EMI), such as alongside utility lines, power lines, and railroad tracks. Nonmetallic all-dielectric cables are also ideal for areas of high lightning-strike incidence.

For comparison, while single-line, voice-grade copper systems longer than a couple of kilometers require in-line signal repeaters for satisfactory performance; it is not unusual for optical systems to go over 100 kilometers (62 mi), with no active or passive processing. Single-mode fiber cables are commonly available in 12 km lengths, minimizing the number of splices required over a long cable run. Multi-mode fiber is available in lengths up to 4 km, although industrial standards only mandate 2 km unbroken runs.

In short distance and relatively low bandwidth applications, electrical transmission is often preferred because of its;

-Lower material cost, where large quantities are not required
-Lower material cost, where large quantities are not required
-Lower cost of transmitters and receivers
-Capability to carry electrical power as well as signals (in appropriately designed cables)
-Ease of operating transducers in linear mode.
-Crosstalk from nearby cables and other parasitical unwanted signals increase profits from replacement and mitigation devices.
-Optical fibers are more difficult and expensive to splice than electrical conductors. And at higher powers, optical fibers are susceptible to fiber fuse, resulting in catastrophic destruction of the fiber core and damage to transmission components.

Because of these benefits of electrical transmission, optical communication is not common in short box-to-box, backplane, or chip-to-chip applications; however, optical systems on those scales have been demonstrated in the laboratory.

In certain situations fiber may be used even for short distance or low bandwidth applications, due to other important features:
-Immunity to electromagnetic interference, including nuclear electromagnetic pulses (although fiber can be damaged by alpha and beta radiation).
-High electrical resistance, making it safe to use near high-voltage equipment or between areas with different earth potentials.
-Lighter weight—important, for example, in aircraft.
-No sparks—important in flammable or explosive gas environments.
-Not electromagnetically radiating, and difficult to tap without disrupting the signal—important in high-security environments.
-Much smaller cable size—important where pathway is limited, such as networking an existing building, where smaller channels can be drilled and space can be saved in existing cable ducts and trays.
-Resistance to corrosion due to non-metallic transmission medium

Optical fiber cables can be installed in buildings with the same equipment that is used to install copper and coaxial cables, with some modifications due to the small size and limited pull tension and bend radius of optical cables. Optical cables can typically be installed in duct systems in spans of 6000 meters or more depending on the duct’s condition, layout of the duct system, and installation technique. Longer cables can be coiled at an intermediate point and pulled farther into the duct system as necessary.
Reference: Wikipedia

  • You must to post comments
Showing 1 result
Your Answer
Post as a guest by filling out the fields below or if you already have an account.
Name*
E-mail*
Website